Google Tag Manager (noscript) -->

Support Center

How to Set up Philips TV

Last Updated: Jul 14, 2015 10:11AM CEST
If you are not comfortable setting up the TV you might consider configuring your router instead.
  1. Before you start this guide you will need to find the out the IP of your router, netmask (subnet), and the IP range used by your router. All this info needs to be entered in step 5. Please see this guide to find out how to get the info needed. Once you have the info you can proceed.
  2. On your TV remote press the Home button on the remote
  3. Go to Setup
  4. Select Network Settings
  5. Select Network Settings >  Network Configuration > and set to Static IP
  6. Then select Static IP Configuration and enter the following:
    IP address: Please enter a valid IP from your home network. When you follow the guides in step 1 you will be able to see the IP used by either your Mac or PC. Change the last digit. Lets say your Mac has the IP 192.168.0.10 then change the last digit to lets say 15.
    Netmask: Normally you can use 255.255.255.0 - if that does not work please consult step 1 for your local info.
    Gateway: The IP of your router.
    DNS 1: 185.37.37.37
    DNS 2: 185.37.39.39
  7. Restart TV

​Important

First step of troubleshooting should always be to restart device(s) and router. Then check your account status in your account home. You should always see 3 green check marks if the device you are using to visit the account home is set up correctly.

If you are getting a proxy/unblocker warning then make sure to read this article.

What is Unlocator?

Unlocator is a DNS service, which allows you to safely browse the Internet without borders. No speed loss and best of all you can try it for free – no credit card needed.

Create a Free Trial

Troubleshooting

Are you stuck ? Then try the troubleshooter.

Start Troubleshooter

Before You Contact Support

  1. Verify that your device or connected router is using Unlocator.
  2. Restart device and router.
  3. Check your account status from a computer or device that is connected to Unlocator by visiting your account home.
  4. If the above steps don’t work please contact support describing your issue and steps taken to fix it.
Contact Support

How to Format an IP Address

Some devices require you to use 3 digits pr. decimal when setting a DNS. You can format our DNS in the following ways:

185.37.37.37
185.37.37.185
185.037.037.037
185.037.037.185


Why are there not more server options?

support@unlocator.com
https://cdn.desk.com/
false
desk
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
false
Invalid characters found
/customer/en/portal/articles/autocomplete