Support Center

How to Setup Cisco Router

Last Updated: Jul 14, 2015 10:26AM CEST
  1. Open your browser and go to either http://192.168.1.1http://192.168.0.1 http://192.168.2.1 
  2. Log into your router. If you have not set a new username and password then leave the username blank and use admin as password
  3. Choose Basic Setup
  4. Make sure Enable DHCP is selected
  5. Fill in DNS servers 185.37.37.37 & 185.37.39.39
  6. Save the settings
  7. Restart router

​Important

First step of troubleshooting should always be to restart device(s) and router. Then check your account status in your account home. You should always see 3 green check marks if the device you are using to visit the account home is set up correctly.

If you are getting a proxy/unblocker warning then make sure to read this article.

What is Unlocator?

Unlocator is a DNS service, which allows you to safely browse the Internet without borders. No speed loss and best of all you can try it for free – no credit card needed.

Create a Free Trial

Troubleshooting

Are you stuck ? Then try the troubleshooter.

Start Troubleshooter

Before You Contact Support

  1. Verify that your device or connected router is using Unlocator.
  2. Restart device and router.
  3. Check your account status from a computer or device that is connected to Unlocator by visiting your account home.
  4. If the above steps don’t work please contact support describing your issue and steps taken to fix it.
Contact Support

How to Format an IP Address

Some devices require you to use 3 digits pr. decimal when setting a DNS. You can format our DNS in the following ways:

185.37.37.37
185.37.37.185
185.037.037.037
185.037.037.185


Why are there not more server options?

support@unlocator.com
https://cdn.desk.com/
false
desk
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
false
Invalid characters found
/customer/en/portal/articles/autocomplete