How to Set Up Unlocator VPN "L2TP" Manually on Tomato Router

1
First, find your Unlocator VPN account credentials
In order to set up a manual VPN connection, you need to use a server address, and your username and password found in your Unlocator account under the VPN tab.
You can locate this page by following these steps:
  • Go to My Account
  • Locate the VPN tab in the bottom-left corner of the page
  • To view your Email and Password: Choose VPN Account Info
    To view the server addresses: Choose Servers List

    You might want to keep these pages open so you could easily copy the info to be used in step 5.

    2
    Launch your web browser. 
    3
    Input your router's local IP address in the address bar. (It is usually 192.168.1.1 or 192.168.0.1).
    4
    Input your router's login credentials when prompted.
    5
    Go to Basic and select Network.
    6
    -Type: L2TP
    -Username: UnlocatorVPN Username See step 1
    -Password: UnlocatorVPN Password See step 1
    -Use DHCP: Check
    -Subnet Mask: 255.255.255.0
    -L2TP Gateway: Input the hostname or IP address of the Unlocator server you wish to connect to. servers list See step 1
    -Options: require-mppe-128
    -Connect mode: Keep-alive
    -Check Interval: 10
    -MTU: Default – 1460
    7
    Click Save.
    8
    Click Start Now.
    Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

    Still need help? Contact Us Contact Us