How to Set Up Unlocator VPN "L2TP" Manually on Arris Router

1
First, find your Unlocator VPN account credentials
In order to set up a manual VPN connection, you need to use a server address, and your username and password found in your Unlocator account under the VPN tab.
You can locate this page by following these steps:
  • Go to My Account
  • Locate the VPN tab in the bottom-left corner of the page
  • To view your Email and Password: Choose VPN Account Info
    To view the server addresses: Choose Servers List

    You might want to keep these pages open so you could easily copy the info to be used in step 8 and 9.

    2
    Launch your web browser. 
    3
    Input your router's local IP address in the address bar. (It is usually 192.168.1.1 or 192.168.0.1)
    4
    Input your router's login credentials when prompted.
    5
    Click on WAN, in your left-side menu.
    6
    Set Connection Type to L2TP.
    7
    Check Enable L2TP.
    8
    Input your UnlocatorVPN Username (email used to create your Unlocator account). See step 1
    9
    For Server Address, input the hostname or IP address of the Unlocator server you wish to connect to. See step 1
    10
    Leave IP Address blank.
    11
    Leave Subnet Mask blank.
    12
    Enable the Idle Timeout option.
    13
    Set Idle Timeout to 300.
    14
    Enable Keep-alive.
    15
    Set Keep-Alive to 30.
    Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

    Still need help? Contact Us Contact Us