How to Set Up Unlocator VPN "PPTP" Manually on TRENDnet Router
1
First, find your Unlocator VPN account credentials In order to set up a manual VPN connection, you need to use a server address , and your username and password found in your Unlocator account under the VPN tab. You can locate this page by following these steps:
Go to My Account
Locate the VPN tab in the bottom-left corner of the page
To view your Email and Password: Choose VPN Account Info
To view the server addresses: Choose Servers List
2
Launch your web browser.
3
Input your router's local IP address in the address bar. (It is usually 192.168.1.1 or 192.168.0.1)
4
Input your router's login credentials when prompted.
5
Click on WAN , in your left-side menu.
6
Set Connection Type to PPTP .
7
Select Dynamic IP .
8
Input our DNS server address: 185.37.37.37
9
For Server IP/Name , input the hostname or IP address of the Unlocator server you wish to connect to. servers list See step 1
10
For PPTP Account , input your UnlocatorVPN Username (email used to create your Unlocator account).
11
For Password , and Retype Password , input your UnlocatorVPN Password. See step 1
12
Set Auto-reconnect to Connect-on-Demand .
13
Set Idle Timeout to 5 minutes .
14
Do not change MTU.
15
Enable MPPE.
16
Click Apply .
Did this answer your question?
Thanks for the feedback
There was a problem submitting your feedback. Please try again later.