How to Set Up Unlocator VPN "L2TP" manually on Mac OS X

First, find your Unlocator VPN account credentials
In order to set up a manual VPN connection, you need to use a server address, and your username and password found in your Unlocator account under the VPN tab.
You can locate this page by following these steps:
  • Go to My Account
  • Locate the VPN tab in the bottom-left corner of the page
  • To view your Email and Password: Choose VPN Account Info
    To view the server addresses: Choose Servers List

    You might want to keep these pages open so you could easily copy the info to be used in step 7.

    Click on the Apple Menu in the upper left corner and select System Preferences.
    Choose Network.
    Click on + to add a new connection.
    Interface: Select VPN.
    VPN Type: Select L2TP over IPSec.
    Service Name: Enter UnlocatorVPN, or any name of your choosing.
    Click Create.
    For Server Address, enter the hostname of the Unlocator server you wish to connect to, Server hostname list can be found here: servers list
    For Account Name, enter your Unlocator account username. See step 1
    Click Authentication Settings.
    For Password, enter your UnlocatorVPN password. See step 1
    For Shared Secret, enter unlocator, then click OK.
    Click Advanced.
    Check Send all traffic over VPN connection, then click OK.
    Click Apply.
    Click Connect.
    Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

    Still need help? Contact Us Contact Us